One of the troubleshooting of the gas geyser not igniting, applies to flue-type unit with water flow sensor device.
Quick No-Ignition Fixes
Basic Checks
✅ Power
- Verify that batteries are aligned in the proper polarity(+/-). Negative should be down closest to you and Positive towards the back.
- Make sure the On/Off switch(if applicable) is turned on, do this by having the Red dot pushed in.
✅ Gas/Water Valves and channels
- Confirm gas valve **fully open**.
- Check water inlet valve isn’t restricted.
- Check that water is flowing through correctly.
- There may be debris within the water adjusting valve and water flow sensor. Remove connections to the inlet and inspect. Remove any debris that may be blocking the water inlet and retry. .
- The gas passage may need to be purged of air. Turn gas to maximum and burners to High on the unit and turn water on/off a few times.
Water Pressure Test
➤ Minimum 0.01MPa required
- Check for sufficient water pressure. The gas geyser must have a minimum of 0.01MPa of sustained pressure to activate the gas burner.
Solving "Ignition is Clicking But Unit Fails to Ignite and No Flame when LED display lights"
Check the Gas Passage:
- Disconnect all gas attachments from the gas geyser and gas valve.
- Pay attention to the solenoid valves and see if working properly.
- Turn your water supply on.
Once your gas geyser starts to click, turn your gas valve on slowly and watch for ignition through the window.
This guide should be followed in case of failure of the appliance to operate correctly. If symptoms persist, please contact nearest Customer Service.